Spooky Ghost Clicker

Designer

STLFLIX

Designer relation

Ingen

Kategori

Subscription Library

Licens

STLFLIX Subscription Ikke mappet til Scout licenskatalog

Designer commercial

STLFLIX Subscription

Først set

2026-09-15 08:05

Sidst set

2026-09-15 08:05

Tags

ghost clicker fidget clicker halloween fantasminha clicker fantasma abóbora light up ghost ghost that glows pumpkin ghost abóbora halloween calabaza halloween fantasmita brillante brinquedo fidget fantasma juguete fidget fantasma halloween fidget toy ghost fidget stl printable ghost toy brinquedo imprimível halloween juguete imprimible halloween glowing ghost fantasma luminoso ghost pumpkin clicker clicker fantasma fidget luminoso sombrero bruja fantasma witch hat ghost ghost lantern fidget

Beskrivelse

3D MODEL DESCRIPTION Press it and the little ghost lights up from the inside. It sits in a pumpkin and glows on demand. - This STL file is recommended for FDM Printers! - 3D Printing Time : Monocolor - 02 Hours, 16 Minutes* (may vary according to your printer model) Multiparts - 02 Hours, 10 Minutes* (may vary according to your printer model) Multicolor - 11 Hours, 04 Minutes* (may vary according to your printer model and the amount of colors in your AMS, in this print we’ve used 03 colors) - Approximately Height: 10 cm (Assembled Files) * Note : Printing time based on a B ambu P1S printer, according to our tests. ATTENTION : “ Multipart” files requires super glue. You Will Need: Led 3V- 1x - Amazon - AliExpress - Mercado Livre Clicker Switch - 1x - Amazon - AliExpress - Mercado Livre Lithium Battery 1220 - 1x - Amazon - Aliexpress - Mercado Livre 3D PRINT SETTINGS (FOR 0.4 MM NOZZLE) - Line Width/ Nozzle: 0.4 mm - First Layer Line Width: 0.48 mm / 120% - Average Speed: 20mm/s (First Layer) / 50mm/s (All the other layers) (Ender like) | 20 mm/s (First Layer) / 250 mm/s (All the other layers on Bambu Lab) - Recommended Initial Layer Height: 0.12 mm - Recommended Layer Height: 0.12 mm - Recommended Perimeters/ Walls: 2. - Recommended Infill (%): 5% (Gyroid) - Needs Support: Yes, (Manual Snug) only in “Ghost” files. - Build Plate Adhesion: No. The parameters above are recommendations made by our staff; if you prefer, you can adapt them according to your preferences. Happy Printing!