Crescent Lantern - Wreath

Designer

STLFLIX

Designer relation

Ingen

Kategori

Subscription Library

Licens

STLFLIX Subscription Ikke mappet til Scout licenskatalog

Designer commercial

STLFLIX Subscription

Først set

2026-09-14 19:50

Sidst set

2026-09-14 20:46

Tags

halloween wreath crescent moon wreath jack-o-lantern wreath pumpkin wreath halloween door decoration halloween wall decoration 3D printed wreath printable halloween decor guirlanda de halloween guirlanda de abóbora decoração de porta halloween decoração de parede halloween lua crescente halloween lanterna halloween corona de halloween guirnalda de halloween calabaza halloween decoración de puerta halloween decoración de pared halloween luna creciente halloween linterna halloween STL halloween FDM halloween decoration

Beskrivelse

3D MODEL DESCRIPTION A crescent moon wreath with jack-o-lanterns and a hanging lantern that turns any wall or door into a full Halloween moment. Print it, hang it, done. - This STL file is recommended for FDM Printers! - 3D Printing Time : Monocolor - 06 Hours, 56 Minutes* (may vary according to your printer model) Multiparts - 07 Hours, 47 Minutes* (may vary according to your printer model) Multicolor - 13 Hours, 57 Minutes* (may vary according to your printer model and the amount of colors in your AMS, in this print we’ve used 03 colors) - Approximately Height: 18 x 20 x 05 cm (Assembled Files) * Note : Printing time based on a Bambu P1S printer, according to our tests. You Will Need: 1x - Candle Led - Amazon - AliExpress - Mercado Livre ATTENTION : “ Multipart” files requires super glue. 3D PRINT SETTINGS (FOR 0.4 MM NOZZLE) - Line Width/ Nozzle: 0.4 mm - First Layer Line Width: 0.48 mm / 120% - Average Speed: 20mm/s (First Layer) / 50mm/s (All the other layers) (Ender like) | 20 mm/s (First Layer) / 250 mm/s (All the other layers on Bambu Lab) - Recommended Initial Layer Height: 0.16 mm - Recommended Layer Height: 0.16 mm - Recommended Perimeters/ Walls: 2. - Recommended Infill (%): 5% (Gyroid) - Needs Support: No. - Build Plate Adhesion: Yes, (Inner Brim) only in “Lens” and “Flashlight” files. - Others: Use (Vase Mode) in the “Lens” file to achieve the desired effect. Use (Concentric) at the top of the layer to achieve a better finish. The parameters above are recommendations made by our staff; if you prefer, you can adapt them according to your preferences. Happy Printing!