Witch Cat Clicker

Designer

STLFLIX

Designer relation

Ingen

Kategori

Subscription Library

Licens

STLFLIX Subscription Ikke mappet til Scout licenskatalog

Designer commercial

STLFLIX Subscription

Først set

2026-09-14 20:48

Sidst set

2026-09-15 04:05

Tags

witch cat clicker fidget clicker halloween fidget toy gato bruxa gatinho bruxo brinquedo fidget halloween juguete fidget halloween gato brujito clicker halloween light up eyes olhos que acendem ojos que brillan black cat halloween gato preto halloween gato negro halloween fidget toy stl printable fidget brinquedo imprimível juguete imprimible clicker 3d print halloween clicker chapéu de bruxa sombrero de bruja witch hat cat clicker gato fidget gato

Beskrivelse

3D MODEL DESCRIPTION A clicker hidden inside a witch hat that lights up the cat's eyes when pressed. Satisfying to click, impossible to put down. - This STL file is recommended for FDM Printers! - 3D Printing Time : Monocolor - 02 Hours, 05 Minutes* (may vary according to your printer model) Multiparts - 01 Hours, 55 Minutes* (may vary according to your printer model) Multicolor - 08 Hours, 24 Minutes* (may vary according to your printer model and the amount of colors in your AMS, in this print we’ve used 04 colors) - Approximately Height: 10 cm (Assembled Files) * Note : Printing time based on a B ambu P1S printer, according to our tests. ATTENTION : “ Multipart” files requires super glue. You Will Need: Led 3V- 1x - Amazon - AliExpress - Mercado Livre Clicker Switch - 1x - Amazon - AliExpress - Mercado Livre Lithium Battery 1220 - 1x - Amazon - Aliexpress - Mercado Livre 3D PRINT SETTINGS (FOR 0.4 MM NOZZLE) - Line Width/ Nozzle: 0.4 mm - First Layer Line Width: 0.48 mm / 120% - Average Speed: 20mm/s (First Layer) / 50mm/s (All the other layers) (Ender like) | 20 mm/s (First Layer) / 250 mm/s (All the other layers on Bambu Lab) - Recommended Initial Layer Height: 0.12 mm - Recommended Layer Height: 0.12 mm - Recommended Perimeters/ Walls: 2. - Recommended Infill (%): 5% (Gyroid) - Needs Support: Yes, (Manual Snug) only in “Hat” files. - Build Plate Adhesion: Yes, (Brim Type) only in “Eyes” files. - Others: In the “Eye” files, use 0% infill and only 1 wall. The parameters above are recommendations made by our staff; if you prefer, you can adapt them according to your preferences. Happy Printing!