Blinky Skull

Designer

STLFLIX

Designer relation

Ingen

Kategori

Subscription Library

Licens

STLFLIX Subscription Ikke mappet til Scout licenskatalog

Designer commercial

STLFLIX Subscription

Først set

2026-09-14 20:48

Sidst set

2026-09-18 08:05

Tags

skull fidget caveira fidget calavera fidget blinky skull caveira piscante calavera parpadeante skull squeeze toy brinquedo caveira halloween juguete calavera halloween halloween skull fidget fidget olho fidget ojo eye pop skull fidget toy imprimível fidget toy imprimible skull stl halloween printable skull toy brinquedo imprimível caveira juguete imprimible calavera squeeze skull caveira espremível calavera apretable halloween fidget stl skull pop eyes olhos saltados ojos saltones

Beskrivelse

3D MODEL DESCRIPTION Squeeze one eye and the other disappears. A skull that blinks on your terms. - This STL file is recommended for FDM Printers! - 3D Printing Time : Monocolor - 01 Hour, 29 Minutes* (may vary according to your printer model) Multipart - 01 Hour, 34 Minutes* (may vary according to your printer model) Multicolor - 06 Hours, 34 Minutes* (may vary according to your printer model and the amount of colors in your AMS, in this print we’ve used 02 colors) Keychain - Monocolor - 01 Hour, 56 Minutes* (may vary according to your printer model) Keychain - Multicolor - 01 Hour, 36 Minutes* (may vary according to your printer model) Keychain - Multicolor - 06 Hours, 36 Minutes* (may vary according to your printer model and the amount of colors in your AMS, in this print we’ve used 02 colors) - Approximately Height: 06 cm (Assembled Files) * Note : Printing time based on a B ambu P1S printer, according to our tests. ATTENTION : “ Multipart” files requires super glue. You Will Need: Rings Key Chain - 1x - Amazon - Aliexpress - Mercado Livre Rings Connector - 1x - Amazon - Aliexpress - Mercado Livre 3D PRINT SETTINGS (FOR 0.4 MM NOZZLE) - Line Width/ Nozzle: 0.4 mm - First Layer Line Width: 0.48 mm / 120% - Average Speed: 20mm/s (First Layer) / 50mm/s (All the other layers) (Ender like) | 20 mm/s (First Layer) / 250 mm/s (All the other layers on Bambu Lab) - Recommended Initial Layer Height: 0.16 mm - Recommended Layer Height: 0.16 mm - Recommended Perimeters/ Walls: 2. - Recommended Infill (%): 5% (Gyroid) - Needs Support: No. - Build Plate Adhesion: No. The parameters above are recommendations made by our staff; if you prefer, you can adapt them according to your preferences. Happy Printing!