Skubbies - Batz

Designer

STLFLIX

Designer relation

Ingen

Kategori

Subscription Library

Licens

STLFLIX Subscription Ikke mappet til Scout licenskatalog

Designer commercial

STLFLIX Subscription

Først set

2026-09-14 19:51

Sidst set

2026-09-14 20:47

Tags

Skubbies Batz bat toy STL Halloween bat figure articulated bat toy skull face toy purple bat 3D print FDM Halloween figure interchangeable face STL pull limb toy boneco articulado morcego boneco morcego Halloween boneco caveira roxo brinquedo morcego impresso FDM rosto intercambiável articulação braço perna muñeco articulado murciélago figura murciélago Halloween muñeco calavera morado cara intercambiable mecanismo articulación juguete murciélago impreso 3D creepy cute bat kawaii Halloween toy collectible Halloween figure figura coleccionable Halloween

Beskrivelse

3D MODEL DESCRIPTION A skull dressed as a bat that leans more kawaii than terrifying. Pull one limb and watch the other spring to life. - This STL file is recommended for FDM Printers! - 3D Printing Time : Monocolor - 09 Hours 16 Minutes* (may vary according to your printer model) Multiparts - 09 Hours 50 Minutes* (may vary according to your printer model) Multicolor - 13 Hours 34 Minutes* (may vary according to your printer model and the amount of colors in your AMS, in this print we’ve used 04 colors) - Approximately Height: 10 cm * Note : Printing time based on a Bambu P1s printer, according to our tests. ATTENTION : files requires super glue. YOU WILL NEED: Split Key Ring with Chain - Amazon - AliExpress - Mercado Livre 12 mm Ring Connector - Amazon - AliExpress - Mercado Livre 3D PRINT SETTINGS (FOR 0.4 MM NOZZLE) - Line Width/ Nozzle: 0.4 mm - First Layer Line Width: 0.48 mm / 120% - Average Speed: 20mm/s (First Layer) / 50mm/s (All the other layers) (Ender like) | 20 mm/s (First Layer) / 250 mm/s (All the other layers on Bambu Lab) - Recommended Initial Layer Height: 0.2 mm - Recommended Layer Height: 0.2 mm - Recommended Perimeters/ Walls: 3. - Recommended Infill (%): 5% (Gyroid) - Needs Support: Yes. Manual normal support. - Build Plate Adhesion: Yes. Brim ears - Others: To print the chains, paint the brim ears only at the ends. The parameters above are recommendations made by our staff; if you prefer, you can adapt them according to your preferences. Happy Printing!