Skubbies - Luppi

Designer

STLFLIX

Designer relation

Ingen

Kategori

Subscription Library

Licens

STLFLIX Subscription Ikke mappet til Scout licenskatalog

Designer commercial

STLFLIX Subscription

Først set

2026-09-14 19:51

Sidst set

2026-09-14 20:47

Tags

Skubbies Luppi werewolf toy STL Halloween werewolf figure articulated wolf toy skull face toy FDM Halloween figure interchangeable face STL pull limb toy boneco articulado lobo boneco lobisomem Halloween boneco caveira FDM brinquedo lobo impresso rosto intercambiável articulação braço perna muñeco articulado lobo figura lobizón Halloween muñeco calavera impreso cara intercambiable mecanismo articulación juguete lobo impreso 3D creepy cute werewolf spooky wolf toy collectible Halloween figure figura coleccionable Halloween

Beskrivelse

3D MODEL DESCRIPTION Part wolf, part nightmare, all attitude. This werewolf-suited skull buddy pulls off a permanent scowl that somehow still manages to be adorable. The limb joint mechanic makes every interaction feel alive. - This STL file is recommended for FDM Printers! - 3D Printing Time : Monocolor - 08 Hours 08 Minutes* (may vary according to your printer model) Multiparts - 09 Hours 07 Minutes* (may vary according to your printer model) Multicolor - 18 Hours 06 Minutes* (may vary according to your printer model and the amount of colors in your AMS, in this print we’ve used 05 colors) - Approximately Height: 10 cm * Note : Printing time based on a Bambu P1s printer, according to our tests. ATTENTION : files requires super glue. YOU WILL NEED: Split Key Ring with Chain - Amazon - AliExpress - Mercado Livre 12 mm Ring Connector - Amazon - AliExpress - Mercado Livre 3D PRINT SETTINGS (FOR 0.4 MM NOZZLE) - Line Width/ Nozzle: 0.4 mm - First Layer Line Width: 0.48 mm / 120% - Average Speed: 20mm/s (First Layer) / 50mm/s (All the other layers) (Ender like) | 20 mm/s (First Layer) / 250 mm/s (All the other layers on Bambu Lab) - Recommended Initial Layer Height: 0.2 mm - Recommended Layer Height: 0.2 mm - Recommended Perimeters/ Walls: 3. - Recommended Infill (%): 5% (Gyroid) - Needs Support: Yes. Manual normal support. - Build Plate Adhesion: Yes. Brim ears - Others: To print the chains, paint the brim ears only at the ends. - The parameters above are recommendations made by our staff; if you prefer, you can adapt them according to your preferences. Happy Printing!