Skubbies - Hex

Designer

STLFLIX

Designer relation

Ingen

Kategori

Subscription Library

Licens

STLFLIX Subscription Ikke mappet til Scout licenskatalog

Designer commercial

STLFLIX Subscription

Først set

2026-09-14 19:51

Sidst set

2026-09-14 20:47

Tags

Skubbies Hex cat toy STL Halloween cat figure articulated cat toy skull face toy gray cat 3D print FDM Halloween figure interchangeable face STL pull limb toy boneco articulado gato boneco gato Halloween boneco caveira gato cinza brinquedo gato impresso FDM rosto intercambiável articulação braço perna muñeco articulado gato figura gato Halloween muñeco calavera gato gris cara intercambiable mecanismo articulación juguete gato impreso 3D creepy cute cat spooky cat toy collectible Halloween figure figura coleccionable Halloween

Beskrivelse

3D MODEL DESCRIPTION A cool gray cat with yellow eyes and a skull face that looks completely unbothered by absolutely everything. The limb mechanism keeps this composed little creature from being too still. - This STL file is recommended for FDM Printers! - 3D Printing Time : Monocolor - 08 Hours 02 Minutes* (may vary according to your printer model) Multiparts - 08 Hours 36 Minutes* (may vary according to your printer model) Multicolor - 14 Hours 26 Minutes* (may vary according to your printer model and the amount of colors in your AMS, in this print we’ve used 04 colors) - Approximately Height: 10 cm * Note : Printing time based on a Bambu P1s printer, according to our tests. ATTENTION : files requires super glue. YOU WILL NEED: Split Key Ring with Chain - Amazon - AliExpress - Mercado Livre 12 mm Ring Connector - Amazon - Amazon - AliExpress - Mercado Livre 3D PRINT SETTINGS (FOR 0.4 MM NOZZLE) - Line Width/ Nozzle: 0.4 mm - First Layer Line Width: 0.48 mm / 120% - Average Speed: 20mm/s (First Layer) / 50mm/s (All the other layers) (Ender like) | 20 mm/s (First Layer) / 250 mm/s (All the other layers on Bambu Lab) - Recommended Initial Layer Height: 0.2 mm - Recommended Layer Height: 0.2 mm - Recommended Perimeters/ Walls: 3. - Recommended Infill (%): 5% (Gyroid) - Needs Support: Yes. Manual normal support. - Build Plate Adhesion: Yes. Brim ears - Others: To print the chains, paint the brim ears only at the ends. The parameters above are recommendations made by our staff; if you prefer, you can adapt them according to your preferences. Happy Printing!