Skubbies - Wispie

Designer

STLFLIX

Designer relation

Ingen

Kategori

Subscription Library

Licens

STLFLIX Subscription Ikke mappet til Scout licenskatalog

Designer commercial

STLFLIX Subscription

Først set

2026-09-14 19:50

Sidst set

2026-09-14 20:47

Tags

Skubbies Wispie ghost toy STL Halloween ghost figure articulated ghost toy skull face toy white ghost 3D print FDM Halloween figure interchangeable face STL pull limb toy boneco articulado fantasma boneco fantasma Halloween boneco caveira branco brinquedo fantasma impresso FDM rosto intercambiável articulação braço perna muñeco articulado fantasma figura fantasma Halloween muñeco calavera blanco cara intercambiable mecanismo articulación juguete fantasma impreso 3D creepy cute ghost spooky ghost toy collectible Halloween figure figura coleccionable Halloween

Beskrivelse

3D MODEL DESCRIPTION A tiny ghost with X eyes and a skull face peeking out from under its sheet, equal parts eerie and irresistible. The arm-and-leg pull mechanic gives this little specter some very lively moves. - This STL file is recommended for FDM Printers! - 3D Printing Time : Monocolor - 07 Hours 54 Minutes* (may vary according to your printer model) Multiparts - 08 Hours 20 Minutes* (may vary according to your printer model) Multicolor - 12 Hours 38 Minutes* (may vary according to your printer model and the amount of colors in your AMS, in this print we’ve used 03 colors) - Approximately Height: 10 cm * Note : Printing time based on a Bambu P1s printer, according to our tests. ATTENTION : files requires super glue. YOU WILL NEED: Split Key Ring with Chain - Amazon - AliExpress - Mercado Livre 12 mm Ring Connector - Amazon - AliExpress - Mercado Livre 3D PRINT SETTINGS (FOR 0.4 MM NOZZLE) - Line Width/ Nozzle: 0.4 mm - First Layer Line Width: 0.48 mm / 120% - Average Speed: 20mm/s (First Layer) / 50mm/s (All the other layers) (Ender like) | 20 mm/s (First Layer) / 250 mm/s (All the other layers on Bambu Lab) - Recommended Initial Layer Height: 0.2 mm - Recommended Layer Height: 0.2 mm - Recommended Perimeters/ Walls: 3. - Recommended Infill (%): 5% (Gyroid) - Needs Support: Yes. Manual normal support. - Build Plate Adhesion: Yes. Brim ears. - Others: To print the chains, paint the brim ears only at the ends. The parameters above are recommendations made by our staff; if you prefer, you can adapt them according to your preferences. Happy Printing!