Skubbies - Moki

Designer

STLFLIX

Designer relation

Ingen

Kategori

Subscription Library

Licens

STLFLIX Subscription Ikke mappet til Scout licenskatalog

Designer commercial

STLFLIX Subscription

Først set

2026-09-14 19:50

Sidst set

2026-09-14 20:47

Tags

Skubbies Moki articulated toy STL Halloween toy STL skull face toy monster toy 3D print FDM articulated figure interchangeable face toy pull limb mechanism boneco articulado Halloween boneco caveira impresso boneco monstro FDM rosto intercambiável articulação braço perna brinquedo impresso 3D muñeco articulado Halloween muñeco calavera impreso figura monstruo FDM cara intercambiable mecanismo articulación juguete impreso 3D creepy cute toy spooky toy STL collectible Halloween figure figura coleccionable Halloween

Beskrivelse

3D MODEL DESCRIPTION A grumpy little monster in a green fuzzy suit, complete with horns and a skull face that means serious business. Pull an arm, a leg pops up! The kind of toy that's impossible to put down. - This STL file is recommended for FDM Printers! - 3D Printing Time : Monocolor - 08 Hours 21 Minutes* (may vary according to your printer model) Multiparts - 08 Hours 53 Minutes* (may vary according to your printer model) Multicolor - 15 Hours 51 Minutes* (may vary according to your printer model and the amount of colors in your AMS, in this print we’ve used 03 colors) - Approximately Height: 10 cm * Note : Printing time based on a Bambu P1s printer, according to our tests. ATTENTION : files requires super glue. YOU WILL NEED: Split Key Ring with Chain - Amazon - AliExpress - Mercado Livre 12 mm Ring Connector - Amazon - AliExpress - Mercado Livre 3D PRINT SETTINGS (FOR 0.4 MM NOZZLE) - Line Width/ Nozzle: 0.4 mm - First Layer Line Width: 0.48 mm / 120% - Average Speed: 20mm/s (First Layer) / 50mm/s (All the other layers) (Ender like) | 20 mm/s (First Layer) / 250 mm/s (All the other layers on Bambu Lab) - Recommended Initial Layer Height: 0.2 mm - Recommended Layer Height: 0.2 mm - Recommended Perimeters/ Walls: 3. - Recommended Infill (%): 5% (Gyroid) - Needs Support: Yes. Manual normal support. - Build Plate Adhesion: Yes. Brim ears. - Others: To print the chains, paint the brim ears only at the ends. The parameters above are recommendations made by our staff; if you prefer, you can adapt them according to your preferences. Happy Printing!