Skubbies - Punki

Designer

STLFLIX

Designer relation

Ingen

Kategori

Subscription Library

Licens

STLFLIX Subscription Ikke mappet til Scout licenskatalog

Designer commercial

STLFLIX Subscription

Først set

2026-09-14 19:50

Sidst set

2026-09-14 20:47

Tags

Skubbies Punki pumpkin toy STL jack-o-lantern figure Halloween pumpkin toy articulated pumpkin character skull face toy FDM Halloween figure interchangeable face STL pull limb toy boneco articulado abóbora boneco jack-o-lantern Halloween boneco caveira abóbora brinquedo abóbora impresso FDM rosto intercambiável articulação braço perna muñeco articulado calabaza figura jack-o-lantern Halloween muñeco calavera calabaza cara intercambiable mecanismo articulación juguete calabaza impreso 3D creepy cute pumpkin spooky pumpkin toy collectible Halloween figure figura coleccionable Halloween

Beskrivelse

3D MODEL DESCRIPTION A jack-o-lantern-headed skull character stitched together with attitude and ready for Halloween to never end. The pull-limb articulation means playtime is just as expressive as the face. - This STL file is recommended for FDM Printers! - 3D Printing Time : Monocolor - 08 Hours 20 Minutes* (may vary according to your printer model) Multiparts - 08 Hours 53 Minutes* (may vary according to your printer model) Multicolor - 14 Hours 52 Minutes* (may vary according to your printer model and the amount of colors in your AMS, in this print we’ve used 04 colors) - Approximately Height: 10 cm * Note : Printing time based on a Bambu P1s printer, according to our tests. ATTENTION : files requires super glue. YOU WILL NEED: Split Key Ring with Chain - Amazon - AliExpress - Mercado Livre 12 mm Ring Connector - Amazon - AliExpress - Mercado Livre 3D PRINT SETTINGS (FOR 0.4 MM NOZZLE) - Line Width/ Nozzle: 0.4 mm - First Layer Line Width: 0.48 mm / 120% - Average Speed: 20mm/s (First Layer) / 50mm/s (All the other layers) (Ender like) | 20 mm/s (First Layer) / 250 mm/s (All the other layers on Bambu Lab) - Recommended Initial Layer Height: 0.2 mm - Recommended Layer Height: 0.2 mm - Recommended Perimeters/ Walls: 3. - Recommended Infill (%): 5% (Gyroid) - Needs Support: Yes. Manual normal support. - Build Plate Adhesion: Yes. Brim ears. - Others: To print the chains, paint the brim ears only at the ends. The parameters above are recommendations made by our staff; if you prefer, you can adapt them according to your preferences. Happy Printing!