Zeus

Designer

STLFLIX

Designer relation

Ingen

Kategori

Subscription Library

Licens

STLFLIX Subscription Ikke mappet til Scout licenskatalog

Designer commercial

STLFLIX Subscription

Først set

2026-07-12 21:09

Sidst set

2026-07-16 20:05

Tags

zeus zeus statue zeus figurine greek god greek mythology god of thunder lightning bolt olympian god king of gods 3d print statue resin statue fdm statue mythology figure greek sculpture printable statue zeus 3d model estátua zeus figura zeus deus grego mitologia grega deus do trovão raio deuses do olimpo rei dos deuses estátua impressa figura mitológica escultura grega miniatura mitologia zeus miniatura impressão 3d mitologia

Beskrivelse

3D MODEL DESCRIPTION The king of the gods, mid-strike and ready to remind everyone who runs Olympus. A statement piece for any shelf that takes mythology seriously. - This STL file is recommended for FDM Printers! - 3D Printing Time : Multicolor - 01 Day, 17 Hours, 16 Minutes* (may vary according to your printer model and the amount of colors in your AMS, in this print we’ve used 02 colors) - Approximately Height: 22 cm * Note : Printing time based on a Bambu P1S printer, according to our tests. ATTENTION : “ Multipart” files requires super glue. 3D PRINT SETTINGS (FOR 0.4 MM NOZZLE) - Line Width/ Nozzle: 0.4 mm - First Layer Line Width: 0.48 mm / 120% - Average Speed: 20mm/s (First Layer) / 50mm/s (All the other layers) (Ender like) | 20 mm/s (First Layer) / 250 mm/s (All the other layers on Bambu Lab) - Recommended Initial Layer Height: 0.16 mm - Recommended Layer Height: 0.16 mm - Recommended Perimeters/ Walls: 2. - Recommended Infill (%): 5% (Gyroid) - Needs Support: Yes, (Auto Grid) if necessary, use (Painted Support) for better quality. - Build Plate Adhesion: Yes, (Brim) only on files that don't adhere well to the printing bed. - Others: Be sure your support profile is optimized for better quality. 3D FILES INCLUDED - SLA - Pre-Supported: Standard STL file version includes all supports (pre-supported). - Solid Model: You must hollow the 3D print model yourself and add the supports as you wish. - Hollow Model: You must add your own supports. The parameters above are recommendations made by our staff; if you prefer, you can adapt them according to your preferences. Happy Printing!