Snoozy Mega Dumplin' - Clicker

Designer

STLFLIX

Designer relation

Ingen

Kategori

Subscription Library

Licens

STLFLIX Subscription Ikke mappet til Scout licenskatalog

Designer commercial

STLFLIX Subscription

Først set

2026-07-12 21:09

Sidst set

2026-07-12 21:09

Tags

dumpling fidget fidget clicker bao fidget sleepy dumpling sleeping dumpling cozy dumpling dumpling toy surprise dumpling dumpling blind box 3d printed fidget fidget toy clicker toy dumpling character asian toy cute toy calm toy sensory toy desk toy pocket fidget gyoza fidget gyoza toy fidget surpresa bolinho sonolento bolinho dormindo bolinho calmo brinquedo fidget clicker fidget gyoza personagem brinquedo surpresa caixinha surpresa brinquedo impresso 3d fidget de mesa brinquedo sensorial boneco gyoza bolinho grande

Beskrivelse

3D MODEL DESCRIPTION Too cozy to care, too soft to put down. This big guy is the sleepy comfort toy you didn't know your desk needed. - This STL file is recommended for FDM Printers! - 3D Printing Time : Monocolor Big - 01 Day, 01 Hours, 40 Minutes* (may vary according to your printer model) Multicolor Big - 01 Day, 02 Hours, 27 Minutes* (may vary according to your printer model and the amount of colors in your AMS, in this print we’ve used 03 colors) - Approximately Height: Big - 10 cm * Note : Printing time based on a Bambu P1s printer, according to our tests. You Will Need: Led 3V - 1x - Amazon - AliExpress - Mercado Livre Clicker Switch - 1x - Amazon - AliExpress - Mercado Livre Lithium Battery 1220 - 1x - Amazon - Aliexpress - Mercado Livre Rings Key Chain - 1x - Amazon - Aliexpress - Mercado Livre Rings Connector - 1x - Amazon - Aliexpress - Mercado Livre ATTENTION : This files requires super glue. 3D PRINT SETTINGS (FOR 0.4 MM NOZZLE) - Line Width/ Nozzle: 0.4 mm - First Layer Line Width: 0.48 mm / 120% - Average Speed: 20mm/s (First Layer) / 50mm/s (All the other layers) (Ender like) | 20 mm/s (First Layer) / 250 mm/s (All the other layers on Bambu Lab) - Recommended Initial Layer Height: 0.12 mm - Recommended Layer Height: 0.12 mm - Recommended Perimeters/ Walls: 2. - Recommended Infill (%): 5% (Gyroid) - Needs Support: Yes, (Painted Grid) only in “Body” and “Basket Up/Up Keychain” files. - Build Plate Adhesion: No. - Others: You will need to apply supports only to the internal bridge of the “Body” file and the top and bottom “Basket” files. The parameters above are recommendations made by our staff; if you prefer, you can adapt them according to your preferences. Happy Printing!