Crocfinity

Designer

cristoper

Designer relation

Ingen

Kategori

Fashion > Other Fashion Accessories

Licens

Creative Commons Attribution ShareAlike Creative Commons — Attribution — Share Alike

$ ↺ SA

Attribution påkrævet; afledte værker skal deles under kompatibel ShareAlike-licens.

Designer commercial

Other

Først set

2026-07-13 05:33

Sidst set

2026-07-14 20:10

Tags

Fashion Other Fashion Accessories

Beskrivelse

Instructions Print without supports, assemble without glue: - Print 1 stud ( parametric_snap_base_Base.stl ) and 1 crocfinity base ( crocfinity-gridbase.stl ): - I recommend 3 walls for the stud - Place the stud through a hole in your Crocs with the crown sticking out the top - Snap the crocfinity base on - Place any 1x1 gridfinity tray of your choice on base - Repeat for other foot If you're going to be walking around with your gridfinity trays on your clogs, I recommend populating the magnet pockets in each corner (they fit 6x2 mm magnets) Fine print The Gridfinity base plate is based on the one generated by https://gridfinitygenerator.com The Gridfinity system itself is licensed under the MIT License and you can read all about it at https://gridfinity.xyz/