Marathon Magnum MC 2.1.5

Designer

Limonero

Designer relation

Ingen

Kategori

Props

Licens

Creative Commons Attribution ShareAlike Creative Commons - Attribution - Share Alike

$ ↺ SA

Attribution påkrævet; afledte værker skal deles under kompatibel ShareAlike-licens.

Designer commercial

None

Først set

2026-07-10 17:33

Sidst set

2026-07-12 16:20

Tags

cosplay cosplay prop cosplay weapon destiny destiny 2 destiny game destiny weapon marathon marathon the game

Beskrivelse

[Update] It's finally done — cost me almost 420 bucks, but it turned out pretty nice, right? A couple of additional thoughts after assembly and painting: If that little latch for the muzzle attachment doesn't work well, you can just leave it off. I've found that a wrap of masking tape holds way better than the latch does. While my friend and I were painting it, I noticed some details aren't quite accurate, and a few things are even straight-up wrong — like the water slide decal patterns. But honestly, I don't care anymore since it's already finished. The magnets can be a bit tricky during assembly. I don't really have a great trick for it — just try to secure them as best you can. You don't have to fill every magnet slot either. Control the number based on how much pull you actually need. In some spots I only put three magnets in, even though I designed five slots for them. I have been busy lately and have finished printing and testing. This is my updated version. Coloring will probably be delayed until June or July, and I will come back to update the photos here at that time. The previously released version was 1.0, which was created when the game was not yet launched with limited references. The current version features a more accurate design, and I have added modular parts so that you can replace them freely.The model requires several magnets of 10mm diameter × 5mm height, 10mm diameter × 3mm height, 8mm diameter × 5mm height, and one magnet of 10×5×3mm. It also needs two springs with a diameter of 4mm and a height of at least 15mm; please refer to the included assembly instructions for details (this is my first time making instructions, so please forgive me if anything is unclear). I am not fully satisfied with the locking mechanism of the muzzle accessories, but I have not found a better solution. Visible wobble may occur due to tolerance issues, which can be improved by post-processing such as sanding and is generally acceptable. I have uploaded STP and F3D files. If you are able to make further modifications, I would greatly appreciate it. I may release version 2.2 in the future, though please do not get your hopes too high. Most patterns have been recessed by 0.3mm for easier painting, masking, or multi-color printing. The number of water decals has been greatly reduced this time, and the water decal sheet is in A5 size.