Wizard Broom - Wind Spinner

Designer

Sevro

Designer relation

Followed

Kategori

Household

Licens

Standard Digital File License

$ ↺

Se platformens konkrete vilkår.

Designer commercial

MakerWorld Commercial License

Først set

2026-07-15 10:58

Sidst set

2026-07-15 10:58

Tags

Harry Potter wizard broom fan Wind Spinner

Beskrivelse

Update 16.06.2026 - Reinforced the propeller blades, - added a new base, - slightly extended the broom handle. Overview: Wind spinner inspired by Harry Potter Instructions: The full set consists of several parts. Wizard: hand-painted in the print profile. It uses only two colors, so it’s perfect for H2C or newest X2D. You can also print it in a single color. Spinner: glue the blades to the spinner and mount it at the end of the broom. A small arrow-shaped pin secures the spinner and should also be glued in place. Place the wizard onto the broom. It’s a tight fit, so no glue is required. Position it carefully to achieve proper balance. The whole model should stand as shown in the photo. Base: screw it to a post and insert the broom with the wizard. If the model is too big for you, you can make it smaller. I printed a 50% reduced version and everything works the same. Only the propeller blades need to be printed on a 0.1mm layer. I also added a print profile with a smaller version. Have Fun :)