makerworld
MF128-2RS Bearing Holder
- Designer
- KenMills
- Designer relation
- Followed
- Kategori
- Hobby & DIY
- Licens
-
Creative Commons Attribution NonCommercial ShareAlike Creative Commons Attribution-Noncommercial-Share AlikeAttribution påkrævet; kommerciel brug er ikke tilladt; ShareAlike gælder for afledte værker.
- Designer commercial
- MakerWorld Commercial License
- Først set
- 2026-07-15 10:58
- Sidst set
- 2026-07-15 10:58
- Tags
Beskrivelse
Mounts MF128-2RS flanged ball bearings used with 8mm rods. I replaced the plastic bearings in my son's rock tumbler with flanged ball bearings. There was very little clearance so the bearings and mounts needed to be as narrow as possible. Each mount uses M3 bolts or screws, with the length dependent the material mounted to. The openings the rods passed through were 10mm, so I also created a drill guide to center on those openings. Be sure to insert each bearing non-flanged side first. The flange should sit flush with the mount when fully seated.
Kandidatvurdering
Opdateret 2026-09-18 13:05
opportunity
Opportunity
44.4
Sub-scores
Der skal mindst to scoremålinger til før udviklingen kan vises.
Hvorfor
- Ingen aktuel trendplacering; curated/importerede snapshots giver ikke trendscore.
- Engagement score 24.3: 33 usage, 16 likes.
- License score 65: designerlicens estimerer ekstra omkostning/friktion og value-for-money; verificer altid rettigheder manuelt.
- Designerlicens value-for-money signal: 339 modeller til rådighed.
- Designer er markeret som followed; relationship score 15.
- Produktmatch-signaler: holder, mount, insert, guide, drill guide.
- Licenssignal fundet; modellen kan være en direkte mulighed, men rettigheder skal verificeres.
Relaterede modeller
Snapshots
| Tid | Rank | Usage | Likes | Hot | Design |
|---|---|---|---|---|---|
| 2026-07-15 10:58 | 87 | 33 | 16 | 14 | - |