The Golden Toilet

Designer

JuliaEbert

Designer relation

Followed

Kategori

Household

Licens

Creative Commons Attribution ShareAlike Creative Commons Attribution-Share Alike

$ ↺ SA

Attribution påkrævet; afledte værker skal deles under kompatibel ShareAlike-licens.

Designer commercial

None

Først set

2026-07-15 10:58

Sidst set

2026-07-15 10:58

Tags

furniture decor miniature model toilet bathroom dollhouse nosupport

Beskrivelse

This little toilet is a fun easter egg to add to your home decor or dollhouse. It measures about 100 mm long when assembled. It has a movable seat and lid, and a pipe down from the bowl in case you want to flush anything down. I've also included STEP files in case you want to modify it. What to print Print either: (Recommended) toilet.3mf. This includes seam and layer height configuration. One each of the included STL files. I recommend printing at 0.15 or 0.16 mm layer height. This requires no supports. All STL files should be correctly oriented for printing on the bed. Assembly Cut a piece of 1.75mm filament about 10 cm long, with an angled tip. Check that this fits through all of the holes in the lid, seat, and base. You might need to scrape out the holes with a small file or craft/xacto knife. Line up the base, seat, and lid and slide the filament through all the hinge holes (6 total). Cut each end of the filament flush with the hinges. If the filament is loose, add a drop of super glue (cyanoacrylate/CA glue) or similar to the ends. Attach the tank to the base by adding glue to the corresponding holes & pegs.