Pioneer Ddj Flx4 Stand

Designer

PaBo

Designer relation

Ingen

Kategori

Hobby & DIY

Licens

Creative Commons Attribution NonCommercial ShareAlike Creative Commons Attribution-Noncommercial-Share Alike

$ ↺ SA

Attribution påkrævet; kommerciel brug er ikke tilladt; ShareAlike gælder for afledte værker.

Designer commercial

None

Først set

2026-07-14 16:37

Sidst set

2026-09-15 20:28

Tags

pioneer ddj flx4 stand feet riser accessory dj accessory ergonomic angled controller gadget

Beskrivelse

Inclined stands for a Pioneer DDJ FLX 4 controller. These 3D printed feet raise your DDJ-FLX4 by approx. 4–5 cm and tilt it slightly. Perfect for a better view of the controller and also much more comfortable working while standing or sitting. Advantages of these stands Stable and non-slip with integrated space for rubber pads 11.6mm Slight tilt of approx. 10° for comfortable work Quick setup: no glue or screws needed Perfectly fitting for the Pioneer DDJ FLX 4 Optional cover cap (caps) to conceal the area that was printed in air Included in the 3MF profile: Both stands (left + right) already placed side-by-side Optimal print settings Recommended settings: Material: PLA or PETG Layer height: 0.2mm Infill 15% Gyroid Walls 2 no supports Optional The small caps (separate 3MF) can simply be glued into the recess if you want to conceal the typical overhang lines. Print time: Approx. 2.5-3 hours per stand Material consumption: Approx. 120gr per stand Note: The DDJ-FLX4 is only slightly raised – no replacement for large risers. Tested with original Pioneer controller. Have fun printing & DJing! Feedback & remixes welcome (attribution + Share-Alike)