Monitor Santa Claus

Designer

Sevro

Designer relation

Followed

Kategori

Household

Licens

Standard Digital File License

$ ↺

Se platformens konkrete vilkår.

Designer commercial

MakerWorld Commercial License

Først set

2026-07-14 16:37

Sidst set

2026-07-15 10:58

Tags

Santa SantaClaus Christmas

Beskrivelse

Another model for my monitor collection. Santa Claus is the most difficult Christmas figurine to model due to its multicolored nature. To save some time and filament, I divided it into many parts for easier and more economical printing. After printing, glue the legs and hair to the torso. Put the face in its place (you can also glue it) and slide the hat in the position as in the photos. The cap fits tightly, but it clicks into place, so you can also take it off and put it on as you wish. Before gluing hair, clean it well from the remnants of supports. The edge of the cap should be slightly edged with a knife, as the filament may be slightly frayed. Below short movie with assembly In the second profile, there is the entire figure of Santa Claus without cuts. You can also print it like that, although I haven't tested it. An additional feature of this model is that it can also grab the edge of the desk :) Check also my other Christmas designs in my collection: https://makerworld.com/pl/collections/2834983-christmas Have Fun