thingiverse
Wobbly Egg – Roly Poly Toy
- Designer
- NAM_3
- Designer relation
- Ingen
- Kategori
- 3D Printing
- Licens
-
Creative Commons Attribution ShareAlike Creative Commons - Attribution - Share AlikeAttribution påkrævet; afledte værker skal deles under kompatibel ShareAlike-licens.
- Designer commercial
- None
- Først set
- 2026-07-12 20:20
- Sidst set
- 2026-07-12 20:20
- Tags
Beskrivelse
This is an egg shaped self-righting toy that wobbles around when you push it. This model prints in three parts that must be glued together. VERY IMPORTANT : Make sure to print each part with the proper settings. They are listed below. Print Settings: TopWobblyEgg: wall loops: 2 infill: 0% seam position: back BottomWobblyEgg: wall loops: 2 or 3 infill: 100% seam position: back I recommend using adaptive/variable layer height Connector: wall loops: your preference infill: your preference seam position: back
Kandidatvurdering
Opdateret 2026-07-15 10:49
ignore
Opportunity
0
Sub-scores
Hvorfor
- thingiverse 7d rank #96.
- Engagement score 2.9: 0 usage, 7 likes.
- License score 75: modellens egen licens indikerer mulig direkte brug med lav betalingsfriktion; verificer altid rettigheder manuelt.
- Kilden indeholder commercial/Patreon/merchant signal; licens skal verificeres manuelt.
- Toy-risk signaler: toy.
- Risk score 90 trækker ned i Opportunity Score.
Snapshots
| Tid | Rank | Usage | Likes | Hot | Design |
|---|---|---|---|---|---|
| 2026-07-12 20:20 | 96 | 0 | 7 | 5 | - |