makeronline
Kobra X and Kobra 4 Stray Redirector
- Designer
- RaccoonEngineering
- Designer relation
- Ingen
- Kategori
- 3D Printer > 3D Printer Parts & Upgrades
- Licens
-
Standard Digital File LicenseSe platformens konkrete vilkår.
- Designer commercial
- None
- Først set
- 2026-07-12 16:40
- Sidst set
- 2026-07-12 16:40
- Tags
Beskrivelse
Worried about filament strands falling off the back of your build plate near the nozzle wiper and into the Y axis slot? It happens. I just took off my bottom cover recently and was surprised the amount of filament debris in there. We created a small ramp/platform to catch the small extrusions and keep them from dropping inside your printer. Simple to install and takes about 2 minutes. 'Remove the four screws holding your bed on using a 2mm allen driver. Sit the bed aside and snap the offramp around the left rear mount as show in picture. Install your bedplate again with the four screws. Done This is designed to be printed in PLA. Make sure you clean all the support material off around the fin so it locations properly.
Kandidatvurdering
Opdateret 2026-07-15 10:49
ignore
Opportunity
0
▼
Sub-scores
Hvorfor
- makeronline 7d rank #83.
- Engagement score 17.2: 16 usage, 9 likes.
- Produktmatch-signaler: mount, cover.
- Ikke-interessante modelsignaler: 3d printer parts, printer parts, parts & upgrades. Modellen afvises efter keyword-filter.
- Opportunity Score er nulstillet, fordi modellen rammer en hard guardrail eller et ikke-interessant keyword-filter.
Snapshots
| Tid | Rank | Usage | Likes | Hot | Design |
|---|---|---|---|---|---|
| 2026-07-12 16:40 | 83 | 16 | 9 | 18 | 3 |