PA10 RawGuard (Probably A 10)

Designer

MysticMesh3D

Designer relation

Ingen

Kategori

Licens

Ukendt Ikke mappet til Scout licenskatalog

Designer commercial

Cults3D commercial license

Først set

2026-07-10 21:40

Sidst set

2026-07-19 08:55

Tags

https://amzn.to/4vvnvUi pokemon card holder pokemon card display top loader toploader holder toploader guard psa slab psa card display trading card holder trading card display card display stand card grading raw card magnetic card holder pokemon display collectible card display card show display tcg display

Beskrivelse

PA10 RawGuard (Probably A 10) Not every card needs to be graded... but that won't stop people from asking for graded prices anyway. The PA10 RawGuard (Probably A 10) is a magnetic top loader guard designed as a fun collectible display piece that pokes fun at one of the biggest jokes in the trading card hobby. If you've ever heard someone say "it would probably grade a 10" while asking graded prices for a raw card, this display is for you. Built around a standard top loader, the PA10 RawGuard gives raw cards the look of a graded slab while making it obvious that it's all in good fun. The custom "Probably A 10" label instantly gets the joke across and is guaranteed to start conversations at card shows, game rooms, shops, or anywhere collectors gather. Like the original RawGuard, the magnetic two-piece design securely snaps around a standard top loader while allowing endless filament color combinations so you can personalize every build. Commercial selling rights are available only to active MysticMesh3D Authorized Merchants with an active Patreon subscription. Features • Magnetic two-piece design • Compatible with standard trading card top loaders • Funny "Probably A 10" parody slab design • Fully customizable with different filament colors • Premium display piece for raw cards • Great conversation starter for collectors and card shows • Quick and easy to print • Great for collectors, game rooms, card shops, and display cases Printing Instructions • Supports are required for the Front Plate. • All other parts print without supports. • Print each part in your preferred filament colors. Assembly Instructions Each PA10 RawGuard requires: • Eight (8) 5x2mm magnets • Adhesive (CA glue or similar) Step 1 Apply a small amount of adhesive inside each magnet pocket. Step 2 Install all eight magnets, making sure the magnet polarity is correct before the adhesive cures. Step 3 Apply adhesive to the back of the Label piece and attach it to the Label Border. Step 4 Glue the completed Label Assembly onto the Front Plate. Step 5 Allow all adhesive to fully cure. Step 6 Snap both halves around a standard trading card top loader. Required Hardware 8× 5x2mm magnets Adhesive (CA glue recommended) Amazon purchase link for magnets (5x2mm): https://amzn.to/4vvnvUi