thingiverse
20 cm paper towel roll holder for garage / workshop / etc.
- Designer
- giobbino
- Designer relation
- Ingen
- Kategori
- 3D Printing
- Licens
-
Creative Commons Attribution ShareAlike Creative Commons - Attribution - Share AlikeAttribution påkrævet; afledte værker skal deles under kompatibel ShareAlike-licens.
- Designer commercial
- None
- Først set
- 2026-09-18 04:20
- Sidst set
- 2026-09-18 08:20
- Tags
Beskrivelse
The holder works with 18 cm diameter, 20 cm wide paper towel rolls. You will need a couple of M6 screws and 10mm nuts for the assembly. More screws are needed for wall fixing. About the blade: since the 3D printer can't make a sharp edge, I put a 0.2 wider edge on the blade. After printing, cut it a bit with wire cutter or scissors, leaving a sharpen edge. Project limit: changing the roll requires to unscrew one of the screws. Good if you change the roll monthly or less, not weekly or daily. Since I didn't find any project for my needs, I quickly design it for my personal use and I decided to share here just in case somebody would need. Be free to take it and modify on your own.
Kandidatvurdering
Opdateret 2026-09-18 10:05
opportunity
Opportunity
38.2
Sub-scores
Hvorfor
- thingiverse 7d rank #99.
- Rank er forbedret fra 12 timers gennemsnit #100.0 til #99.
- Engagement score 4.6: 1 usage, 8 likes.
- License score 75: modellens egen licens indikerer mulig direkte brug med lav betalingsfriktion; verificer altid rettigheder manuelt.
- Kilden indeholder commercial/Patreon/merchant signal; licens skal verificeres manuelt.
- Produktmatch-signaler: holder, case.
- Licenssignal fundet; modellen kan være en direkte mulighed, men rettigheder skal verificeres.
Snapshots
| Tid | Rank | Usage | Likes | Hot | Design |
|---|---|---|---|---|---|
| 2026-09-18 08:20 | 99 | 1 | 8 | 2 | - |
| 2026-09-18 04:20 | 100 | 1 | 8 | 1 | - |