Fidget Pumpkin

Designer

makerxdesigns

Designer relation

Ingen

Kategori

Seasonal/Halloween & Fall

Licens

4a9a1c80-1303-42c4-8d18-e6afb0f3cf05/makerx-designs-license.pdf Ikke mappet til Scout licenskatalog

Designer commercial

None

Først set

2026-09-17 00:30

Sidst set

2026-09-17 00:30

Tags

fidget fidget toy desk toy desk fidget tactile sensory toy print in place pumpkin halloween fall autumn nested rings multicolor three color no supports pla makerx

Beskrivelse

The "Keeps Your Hands Busy" Fidget Pumpkin A fidget toy for your desk. It sits flat as a pumpkin, and every way you move the stem gives it a different look. WAYS TO PLAY - Twist the Stem: Leave it flat on the desk and twist. The rings shift against each other into mesmerizing designs. - Push and Pull: Slide the stem from side to side and the rings ripple off-center for a whole different set of visuals. - Lift It Up: Raise it by the stem and the 18 rings drop into a scalloped cone. - Hear It Settle: Raise and lower it on the desk and it makes a satisfying sound as the rings come back down. - Textured Stem: The stem is textured, so it has a tactile feel under your fingers while you fidget. WHAT MAKES IT WORK - Prints in Place: One print, no assembly. All 18 rings and the stem come off the plate already captured inside each other. - Tuned Gaps: The gap between rings grows from about 1mm at the stem to about 2mm at the rim, so the outer rings still move freely instead of binding up. - Stays Together: The ring walls are angled so each ring stays captured by its neighbors while you twist, slide and lift it. - Three Colors, Two Swaps: Black ring bodies, orange faces and a brown stem, for only two filament changes and under 3g of purge. CHECK YOUR BED FIRST - 179 x 174mm across and 45mm tall with the stem. Leave room beside it for the prime tower if you print it in color. PRINT SETTINGS No supports required | no brim | 0.20mm layer height | 2 walls | 10% grid infill | PLA Printed on a Creality Hi 2 in 5h 2m and 127g. Happy fidgeting!