Moon Lamp

Designer

Westtech_3D

Designer relation

Followed

Kategori

Household

Licens

Standard Digital File License

$ ↺

Se platformens konkrete vilkår.

Designer commercial

Patreon

Først set

2026-09-14 20:16

Sidst set

2026-09-14 20:16

Tags

mond moon lamp decor deco decoration led modern gift

Beskrivelse

🌙 Moon Lamp – modern design and easy assembly This stylish moon lamp provides pleasant indirect lighting and can be assembled with just a few components. The curved diffuser distributes light evenly, while the integrated guides hold the LED strip securely in place. 🛠️ Recommended print settings Housing and base Optimal layer height: 0.16 mm for clean details Time-saving alternative: 0.20 mm Diffuser Recommended layer height: 0.20 mm Best printed with white or slightly translucent filament. This creates a soft and even light output. 💡 Required accessories LED strip length: 25 cm A flexible LED strip with self-adhesive backing is particularly easy to install. Before installation, check that the LED strip is working properly. 🔧 Assembly Insert the 25 cm long LED strip along the inner curve. The LED strip must run behind the seven round guides – i.e. between the guides and the rear housing wall. The guides prevent the LED strip from detaching when it heats up. Feed the connection cable neatly through the designated opening. Make sure the LED strip lies flat everywhere. Then carefully insert the diffuser from above. The wider end goes into the large guide on the right side, the narrower end goes into the small guide on the left side. Bend the diffuser only gently and do not kink it. Both ends must sit fully in the intended guides. Then align the upper housing part and place it down evenly. Before fully closing, check that the diffuser is seated correctly and no cables are pinched. Finally place the lamp on the base. The base was not shown separately in the assembly images, as the attachment is self-explanatory. 🔦 Tip Turn on the LED strip one more time before final assembly. This allows you to check that all LEDs are working and light is evenly distributed through the diffuser. I wish you much joy with printing and crafting! If you have questions or want to share your result, I look forward to your feedback! Happy Printing! Membership Information on commercial licensing on MakerWorld Join