Minimalist Elevated Pet Bowl Stand (Cat / Dog Feeder) – Scalable

Designer

Roman Bednář

Designer relation

Ingen

Kategori

Household > Pets

Licens

Creative Commons Attribution NonCommercial ShareAlike Creative Commons — Attribution — Noncommercial — Share Alike

$ ↺ SA

Attribution påkrævet; kommerciel brug er ikke tilladt; ShareAlike gælder for afledte værker.

Designer commercial

None

Først set

2026-09-14 19:50

Sidst set

2026-09-14 20:52

Tags

dog pet feeder cat stand bowl lab food petg accessories scalable raised elevated bambu

Beskrivelse

Ergonomic Elevated Dual Pet Bowl Stand A sleek, modern, and sturdy elevated bowl riser designed for cats, puppies, and small dogs. Raising the feeding station promotes a more natural neck posture during eating and drinking, helping to improve digestion and reduce neck strain. The design incorporates a lightweight honeycomb grid between the bowl cutouts, saving filament while adding a clean, modern aesthetic. Key Features - Ergonomic Eating Angle: Elevates water and food to reduce stress on your pet's neck, joints, and spine. - Modern Honeycomb Lattice: Center hexagonal pattern saves print time and material without sacrificing structural strength. - Arch Cutouts: Side and front arched cutouts make picking up, moving, and cleaning underneath effortless. - 100% Scalable: Need a larger or smaller bowl size? Uniformly scale the model in your slicer (X/Y/Z) to match your custom stainless steel or ceramic pet bowls. - Default Inner Ring Diameter: Designed to fit standard ~115–120 mm (outer lip ~130–135 mm) pet bowls at 100% scale. 💡 Sizing & Scaling Guide If your bowls have a different rim diameter: - Measure the outer diameter of your bowl below the rim (the diameter of the hole needed). - Divide your measured bowl diameter by the model's hole diameter ( ~118 mm ) and multiply by 100 to get your scale percentage in Bambu Studio / OrcaSlicer. - Example: If your bowl needs a 140 mm hole: (140 / 118) * 100 = ~118.6% scale . Print Settings Parameter Recommended Setting Material: PETG (preferred for water resistance, easy washing, and durability) or PLA Layer Height: 0.20 mm (Standard) Walls / Perimeters: 3 to 4 (recommended for rigid side legs) Infill Density: 15% Infill Pattern: Gyroid Supports: None (print upside down / top face flat on the build plate as sliced) Brim: use 5mm outer brim