The Magpie Clip

Designer

Noodle

Designer relation

Ingen

Kategori

Hobby & Makers > Other Ideas

Licens

Creative Commons Attribution NonCommercial ShareAlike Creative Commons — Attribution — Noncommercial — Share Alike

$ ↺ SA

Attribution påkrævet; kommerciel brug er ikke tilladt; ShareAlike gælder for afledte værker.

Designer commercial

None

Først set

2026-07-24 11:53

Sidst set

2026-07-24 20:41

Tags

screws magnet cap accessory toolholder bits fastprint lifehack baseballcap bitsholder lastmeters

Beskrivelse

You will need 2 neodymium magnets, round flat, the stronger the better, diameter 8 x 3 mm Print Instructions - 0,4 nozzle 0,20mm layer height. - no supports - I recommend the use of brim - pause to insert the magnets (settings in the 3mf file) - be careful if you use hardened steel nozzle because the magnets! you might need to glue them to keep them in place. - when you prepare the magnets place them in a way that the sides snap together. Place them exactly the same way, in the slots of the model