Multimeter Tweezers

Designer

NickSoft

Designer relation

Ingen

Kategori

Hobby & Makers > Electronics

Licens

Creative Commons Attribution NonCommercial ShareAlike Creative Commons — Attribution — Noncommercial — Share Alike

$ ↺ SA

Attribution påkrævet; kommerciel brug er ikke tilladt; ShareAlike gælder for afledte værker.

Designer commercial

None

Først set

2026-07-18 10:17

Sidst set

2026-07-19 08:10

Tags

multimeter tweezers probes

Beskrivelse

I made this model from scratch. The original design is really good, but I wasn't satisfied with the probe holders. The walls were too thin, and the rounded bottom didn't print well and eventually snapped. Even though I redesigned the model from scratch, I wanted to credit the original author Print@Hive for the arms and spring mechanism, which I based my design on. It's a great design. I printed in PLA, 0.15mm layers, 10% gyroid infill (you don't want it too stiff). I'll probably reprint in PETG or ABS. Update: I just printed the 10mm model. The Mastech probes I have are not 10mm everywhere. They get thinner at the back, so they are not as firmly attached. Post your makes/comments if it works for you. Does it need to be tighter?