Potato Cannon Rockets

Designer

FatChicken0707

Designer relation

Ingen

Kategori

Sport & Outdoors

Licens

Creative Commons Attribution ShareAlike Creative Commons - Attribution - Share Alike

$ ↺ SA

Attribution påkrævet; afledte værker skal deles under kompatibel ShareAlike-licens.

Designer commercial

None

Først set

2026-07-16 19:00

Sidst set

2026-07-19 00:20

Tags

cannon gun Hand Cannon potato cannon potato gun potato gun ammo potato gun ammunition potato gun mod potato gun projectile potato gun shell projectile rocket

Beskrivelse

These rockets shoot unbelievably far and well. It was designed for a 1 inch barrel cannon, but could probably be scaled up for 1.5 and 2 inch cannons. I usually use a plunger behind them (which helps create a better seal and transfer more of the energy). My cannon was able to fire these at around 70 m/s which is quite fast for a simple hairspray cannon. The rocket is designed so that the tip is denser than the tail, which helps it fly straight. Notes: The bit dart is designed to perfectly accommodate a 1/4 inch screw driver bit (Phillips works best, you can buy them in bulk for cheap on Amazon.) The open plunger is intended to offer a less dangerous seal, as well as to direct pressure inside the bottom of some rockets. It also tends to catch the wind and fall to the ground faster than the closed plunger. Plungers: lightweight, low infill if any Rockets: 100% infill Supports: none Bed adhesion: raft or brim, unless you are very confident in your printer's ability to print tall and thin objects with little bed contact ⚠️IMPORTANT⚠️ You may need to scale the models in Cura. Refer to the gallery pictures to determine your diameter, as pipes usually have misleading inner diameters. let me know if you would like the SLDPRT files for these models. If you are interested, I also have a remote ignition system for aerosol powered cannons available in my profile.