Bambu Lab A1 Fan Holder (Attached to the Screen)

Designer

yekta

Designer relation

Followed

Kategori

3D Printer

Licens

Creative Commons Attribution

$ ↺

Attribution påkrævet.

Designer commercial

Patreon

Først set

2026-07-15 10:58

Sidst set

2026-07-15 10:58

Tags

fan holder fan bambu lab a1 bambu a1 a1 a1 accessory automation automatic printer automation screen over screen bambu

Beskrivelse

This is a fan holder for Bambu Lab A1. It is designed to be used in a automation setting. I use it to automate my Bambu Lab A1 based on the brilliant video of Factorian Design: Automate your Bambu Lab A1 & A1 Mini!. It is designed for Noctua NF-F12 but might work with other 120mm fans too. There is a compartment at the back for keeping a PCB and cables (I'm using a voltage regulator). Here is my edited G-code based on his work: github.com/yekta/bambu-a1-gcodes. Please be careful if you are going to use these G-codes and test it throughly and carefully. Non-printed part requirements: M3 30mm (35mm is fine too) screw → Quantity: 2 → For screwing the fan in place M3 nut → Quantity: 2 → For securing the screws in place Boost Me (for free) You have my permission to improve the model, share it, produce it, sell it. Just don't re-upload it without any changes (basically don't have malicious intent). I added the STEP and SolidWorks files so that you can edit easier. If you are using Onshape, you can copy and edit the entire project using the link below. Boost → Model link on Onshape ← There is also a button holder for activating and deactivating the fan. It can be found here: Link to the Button Holder.