GIF

Designer

MeasureOnce

Designer relation

Ingen

Kategori

Toys & Games

Licens

Standard Digital File License

$ ↺

Se platformens konkrete vilkår.

Designer commercial

Patreon

Først set

2026-07-09 12:56

Sidst set

2026-07-09 17:50

Tags

nasa fabric nasa earth Fidget fidget toy Toy globe fidget 2 click nasa-fabric fidget toy adult office adhd ball fidget ball sphere sphere ball ball fidget balls round fidget ball toy sphere toy decor 'decor fidgeting planet h2d h2c p2s x2d fun projecthailmary project hail mary project hailmary

Beskrivelse

Boost Me (for free) Please boost if you like my model! Boost Commercial License - https://www.patreon.com/c/measureonce/home NASA Fabric Collection - https://makerworld.com/en/collections/17685211-nasa-fabric-models PLEASE READ! Important Notes: CLEAN YOUR BUILDPLATE AND USE GLUE BEFORE PRINTING! LAYER ADHESION IS VERY VERY IMPORTANT USE PLA MATTE or PLA BASIC. This model has not been tested with silk filaments. I do not recommend using them due to the potential for over extrusion which can cause the layers to fuse If you are using the NO AMS Version, Please use a layer height of 0.16mm. Do not change this value. If it does get changed, the color swaps will not be applied to the appropriate layer and the part will come out looking off. -------------------------------------------------------------------------------------------------------------------------------------------------------------------- This model uses 62 4x2 magnets. Maker's Supply Store - https://us.store.bambulab.com/products/round-magnet?id=42102911074440 Amazon Link - https://www.amazon.com/dp/B0F4MYLY85 Print Settings: Filament: Only PLA matte or PLA basic Layer height: 0.16 Walls: 4 Wall Generator: Arachne Color Swaps: **************WARNING!! LAYERS CORRESPOND TO A LAYER HEIGHT OF 0.16. IF YOU CHANGE THE LAYER HEIGHT THEN THESE LAYER SWAPS WILL NOT APPLY AND YOUR PRINT WILL NOT LOOK AS INTENDED. ********************* Start: Black Layer 54: Blue Layer 58: Green Layer 60: White Magnet Assembly: The magnets will need to be glued in. Start putting magnets of the same polarity on one side of each lobe. Work your way around clockwise, only putting magnets of the same polarity onto the same side of each lobe. Once all the magnets with the same outward facing polarity are assembled, flip the magnets over and repeat. See image below