Triceratops - Dinosaur - Hueforge

Designer

Sarge

Designer relation

Followed

Kategori

Generative 3D Model

Licens

Standard Digital File License

$ ↺

Se platformens konkrete vilkår.

Designer commercial

MakerWorld Commercial License

Først set

2026-07-15 10:58

Sidst set

2026-07-15 10:58

Tags

dino dino 2026 dinosaur triceratops dino art dinosaur art hueforge HUE FORGE wallart wall art picture painting filament painting filamentpainting decor home decor decoration home decoration cretaceous jurassic jurassicpark jurassic park dinosaurs jurassic world trex T-Rex paleontology paleoart 2d art art 2d3d 2d 3d 2d 3d art sarge jurassic world dominion tyrannosaurus rex fossil jurassic world fallen kingdom velociraptor fossils animal animals illustration

Beskrivelse

Membership If you would like to sell any of my Makerworld prints, a Commercial License is available. Join Boost Me (for free) If you like it. I would appreciate it if you could leave a rating too. Boost If you print it, rate it. I put in the work. Rating helps me to keep doing that. I recommend using my print profiles for best results. They are setup and ready to print. Just select your filaments and the correct buildplate. I would also recommend reading below in full. Send me a message if you have questions. If you would like to sell my Hueforges a Commercial Licence Subscription is available. Do not sell my prints without it please. If you do not have an AMS, just delete the filament changes and replace them with pauses instead. Then you can change filament manually when it pauses at the correct layer. Important: I have used a height range modifier in my print profiles for quicker printing. The layer swap numbers in the print profile will not match the ones written below in the print instructions. Do not worry about this. You CANNOT adjust the Z axis scaling on a Hueforge. It will not come out as intended. You can change the X and Y values to scale the picture up or down though. To ensure that the print looks the same as mine you must use the same filaments I did (listed below). If you do not, your results will not be exactly the same as shown. (It may still turn out great…..or it may not). What you see in the slicer will not accurately show the final result. Do not worry about this. Hueforge uses colour blending, but it does not show in the slicer. Please ensure your filament flow ratios are properly calibrated to get the best results. You may see a floating regions error. This can be ignored. Printing Instructions Print at 100% infill with a layer height of 0.08mm with a base layer of 0.24mm. Remember to select the correct plate type for your printer. Filaments Used: PLA BambuLab Basic Black Transmission Distance: 0.6 PLA BambuLab Basic Blue Gray Transmission Distance: 2.3 PLA BambuLab Basic Orange Transmission Distance: 4.4 PLA BambuLab Basic Jade White Transmission Distance: 5.9 Swap Instructions: Start with Black At layer #15 (1.36mm) swap to Blue Gray At layer #17 (1.52mm) swap to Black At layer #18 (1.6mm) swap to Orange At layer #22 (1.92mm) swap to Jade White for the rest.