Gengar - Pokemon - Hueforge

Designer

Sarge

Designer relation

Followed

Kategori

Generative 3D Model

Licens

Standard Digital File License

$ ↺

Se platformens konkrete vilkår.

Designer commercial

MakerWorld Commercial License

Først set

2026-07-15 10:58

Sidst set

2026-07-15 10:58

Tags

Pokemon Pokemon Go Pokemon TCG hueforge hue forge anime game games gamer gaming pokemon art art 2d art 2d 3d painting filamentpainting filament painting decor home decor gaming room decoration wallart wall art gift gengar pikachu eevee

Beskrivelse

Membership If you would like to sell any of my Makerworld prints, a Commercial License is available. Join Boost Me (for free) If you like it. I would appreciate it if you could leave a rating too. Boost If you print it, rate it. I put in the work. Rating helps me to keep doing that. I recommend using my print profiles for best results. They are setup and ready to print. Just select your filaments and the correct buildplate. I would also recommend reading below in full. Send me a message if you have questions. If you would like to sell my Hueforges a Commercial Licence Subscription is available. Do not sell my prints without it please. Important: You CANNOT adjust the Z axis scaling on a Hueforge. It will not come out as intended. You can change the X and Y values to scale the picture up or down though. To ensure that the print looks the same as mine you must use the same filaments I did (listed below). If you do not, your results will not be exactly the same as shown. (It may still turn out great…..or it may not). What you see in the slicer will not accurately show the final result. Do not worry about this. Hueforge uses colour blending, but it does not show in the slicer. Please ensure your filament flow ratios are properly calibrated to get the best results. You may see a floating regions error. This can be ignored. Printing Instructions Print at 100% infill with a layer height of 0.04mm with a base layer of 0.20mm. Remember to select the correct plate type for your printer. Filaments Used: PLA BambuLab Matte Charcoal Black Transmission Distance: 0.6 PLA Esun Purple Transmission Distance: 1 PLA Esun PLA+ White Transmission Distance: 7.9 Swap Instructions: Start with Black At layer #23 (1.08mm) swap to Purple At layer #29 (1.32mm) swap to White for the rest.