Bebop - TMNT - Hueforge

Designer

Sarge

Designer relation

Followed

Kategori

Generative 3D Model

Licens

Standard Digital File License

$ ↺

Se platformens konkrete vilkår.

Designer commercial

MakerWorld Commercial License

Først set

2026-07-15 10:58

Sidst set

2026-07-15 10:58

Tags

TMNT tmnt art tmnt bebop bebop color drop sarge hueforge hue forge 2d art art 2d3d 2d 3d wallart wall art decor home decor gaming room game gaming gamer teenage mutant teenage mutant ninja turtles teenage mutant ninja turtles bebop raphael Donatello Michelangelo leonardo april oneil april o'neil april o neil comic comics film films movie movies anime tv series tv show tmnt comic

Beskrivelse

Membership If you would like to sell any of my Makerworld prints, a Commercial License is available. Join Boost Me (for free) If you like it. I would appreciate it if you could leave a rating too. Boost If you print it, rate it. I put in the work. Rating helps me to keep doing that. I recommend using my print profiles for best results. They are setup and ready to print. Just select your filaments and the correct buildplate. I would also recommend reading below in full. Send me a message if you have questions. There are two print profiles included. One is for a new type of Hueforge called a “Color Drop” and the other profile is a traditional Hueforge . If you use the Color Drop version it will print quicker, but an AMS or other MMU is required. With the traditional Hueforge print profile you can print it like any other Hueforge using an AMS/MMU or manually. If you would like to sell my Hueforges a Commercial Licence Subscription is available. Do not sell my prints without it please. Important: If you want to change filament manually without an AMS or MMU, just replace the filament changes in my print profile with pauses on the same layer. You CANNOT adjust the Z scaling on a Hueforge. It will not come out as intended. You can change the X and Y values to scale the picture up or down though. (To print it on the A1 Mini, scale it down to 180 x 180 or less. Only scale the X and Y. Not the Z). To ensure that the print looks the same as mine you must use the same filaments I did (listed below). If you do not, your results will not be exactly the same as shown. (It may still turn out great…..or it may not). What you see in the slicer will not accurately show the final result. Do not worry about this. Hueforge uses colour blending, but it does not show in the slicer. Please ensure your filament flow ratios are properly calibrated to get the best results. You may see a floating regions error. This can be ignored. On the traditional Hueforge print profile I have used a height range modifier for quicker printing. The layer swaps will not match the swap instructions below. Do not worry about this. Printing Instructions Print at 100% infill with a layer height of 0.04mm with a base layer of 0.20mm. Remember to select the correct plate type for your printer. Filaments Used: PLA BambuLab Matte Charcoal Transmission Distance: 0.6 PLA+ Esun Purple Transmission Distance: 1.0 PLA BambuLab Basic Blue Gray Transmission Distance: 2.3 PLA BambuLab Tough+ White Transmission Distance: 6.4 Swap Instructions (If not using my print profile): Start with Charcoal Black At layer #16 (0.8mm) swap to Purple At layer #22 (1.04mm) swap to Charcoal At layer #24 (1.12mm) swap to Blue Gray At layer #30 (1.36mm) swap to White for the rest.