The Lost Boys - Hueforge

Designer

Sarge

Designer relation

Followed

Kategori

Generative 3D Model

Licens

Standard Digital File License

$ ↺

Se platformens konkrete vilkår.

Designer commercial

MakerWorld Commercial License

Først set

2026-07-15 10:58

Sidst set

2026-07-15 10:58

Tags

hueforge hue forge lost boys the lost boys kiefer sutherland jason patric corey haim michael david the lost boys david the lost boys michael horror horror film horror movie vampire vampires vampire movie star santa carla '80s 80's 80's movies cry little sister the lost boys movie the lost boys film movie film decor home decor wall art wallart picture painting filament painting filamentpainting 2d art art 2d 3d 2d 3d art horror art horror fan cult classic

Beskrivelse

Membership If you would like to sell any of my Makerworld prints, a Commercial License is available. Join Boost Me (for free) If you like it. I would appreciate it if you could leave a rating too. Boost If you print it, rate it. I put in the work. Rating helps me to keep doing that. I recommend using my print profiles for best results. They are setup and ready to print. Just select your filaments and the correct buildplate. I would also recommend reading below in full. Send me a message if you have questions. If you would like to sell my Hueforges a Commercial Licence Subscription is available. Do not sell my prints without it please. Important: If you want to change filament manually without an AMS or MMU, just replace the filament changes in my print profile with pauses on the same layer. You CANNOT adjust the Z scaling on a Hueforge. It will not come out as intended. You can change the X and Y values to scale the picture up or down though. (To print it on the A1 Mini, scale it down to 180 x 180 or less. Only scale the X and Y. Not the Z). To ensure that the print looks the same as mine you must use the same filaments I did (listed below). If you do not, your results will not be exactly the same as shown. (It may still turn out great…..or it may not). I have used a height range modifier for quicker printing. The layer swaps will not match the swap instructions below when using my print profile. Do not worry about this. Just hit print. Please ensure your filament flow ratios are properly calibrated to get the best results. You may see a floating regions error. This can be ignored. What you see in the slicer will not accurately show the final result. Do not worry about this. Hueforge uses colour blending, but it does not show in the slicer. Printing Instructions Print at 100% infill with a layer height of 0.04mm with a base layer of 0.2mm. Remember to select the correct plate type for your printer. Filaments Used: PLA BambuLab Matte Charcoal Black Transmission Distance: 0.6 PLA BambuLab Basic Maroon Red Transmission Distance: 1.5 PLA BambuLab Basic Blue Gray Transmission Distance: 2.3 PLA BambuLab Tough+ White Transmission Distance: 6.4 Swap Instructions (If not using my print profile): Start with Black At layer #20 (0.96mm) swap to Maroon Red At layer #24 (1.12mm) swap to Charcoal At layer #27 (1.24mm) swap to Blue Gray At layer #33 (1.48mm) swap to White for the rest.