Daisy Wall Decor - Tribal Bloom

Designer

kayaco

Designer relation

Ingen

Kategori

Art

Licens

Creative Commons Attribution NonCommercial ShareAlike Creative Commons - Attribution - Non-Commercial - Share Alike

$ ↺ SA

Attribution påkrævet; kommerciel brug er ikke tilladt; ShareAlike gælder for afledte værker.

Designer commercial

None

Først set

2026-07-10 12:25

Sidst set

2026-07-14 20:24

Tags

3D FLOWERS 3d wall art bloom DAISY daisy decor daisy model daisy wall decor flower flower decor sunflower decor Wall Art wall decoration

Beskrivelse

Maybe you'd like to buy me a coffee (: https://www.buymeacoffee.com/YOdesign Daisy Wall Decor - Tribal Bloom - This design faithfully captures the intricate details of a real daisy while featuring elegant tribal patterns on the petals. These textured details not only enhance its appearance but also help conceal layer lines for a cleaner, more refined finish. Tips 1- Glued Assembly: The design is intended for glued assembly, resulting in a stronger and more rigid final piece. 2-Three Available Sizes: 60 cm, 43 cm, and 36 cm in overall diameter. To print the 60 cm version, print only the parts labeled "60cm". The same applies to the 43 cm and 36 cm versions—use only the parts labeled with the corresponding size. Since the assembly is straightforward and does not require precise alignment, you can also scale the model to your preferred size before printing. The original design was created at 60 cm, which is the largest size that fits on a standard 220 × 220 mm print bed. The model (60cm) has been print-tested, and photos of the finished print are included in the images. 3- Petal Printing: The petals can be printed in multiples. For minimal supports and the best possible surface finish, it is recommended to print the petals in the orientation shown in the images. 4- Center Priniting: Using Snug supports allows the daisy center to fit perfectly on the build plate. Since this is a large part and does not require significant mechanical strength, it can be printed with a low infill density (around 3%) to save filament. My Print Settings Quality Layer Height: 0.16 mm Strength Wall Loops: 2 Top Shell Layers: 3 Bottom Shell Layers: 3 Sparse Infill Density: 3% Sparse Infill Pattern: Gyroid Support Type: Normal (auto) Style: Snug Thresold Angle: 15 Interface Pattern: Grid Interface Spacing: 0.3 Others Brim width: 5 mm