Oni - Japandi Planter with Legs

Designer

Maxx_Design

Designer relation

Followed

Kategori

Household

Licens

Standard Digital File License

$ ↺

Se platformens konkrete vilkår.

Designer commercial

Patreon

Først set

2026-07-15 10:58

Sidst set

2026-07-15 10:58

Tags

modern designer plant pot planter legs

Beskrivelse

Boost Me (for free) If you enjoy my designs, you can support my work with a boost! Boost Meet Oni, a Japandi-inspired planter with soft ribbed curves and playful little legs - designed to bring a calm, modern touch to any desk, shelf, or windowsill. No AMS required for printing, the legs simply screw into the pot. There are two native sizes available, each with short and long legs. If you want to print a custom size, try to scale up the version closest to your desired size. Medium: Inner Height: ~9,3cm Inner Diamater (Minimum): ~9,4cm Small: Inner Height: ~5,3cm Inner Diamater (Minimum): ~5,4cm Printing (Important) For best results, I disabled the aux cooling fan. This will greatly reduce the “hull line” at the bottom. If you change the filament settings, these changes could be discarded, so make sure to put it to 0% again in the filament settings (Cooling tab). P2S users beware: The P2S sometimes turns the aux fan on even when set to 0%. You must then disable it again after the first layer is fully printed. Slice Settings All my profiles are ready to print. If you decide to slice the files yourself, I recommend adding a manual support at the bottom of the top to help with overhangs. To reduce stringing and artifacts, I also recommend disabling "Reduce infill retractions" (in Other) and to enable "Avoid crossing walls" (in Quality). If you like this design, check out my other planters! https://makerworld.com/en/collections/4275132-planters Commercial license available on Patreon and MakerWorld! Membership Get a commercial license for my designs by becoming an Authorized Seller! Join