Bambu AMS RepRack Mount

Designer

K2_Kevin

Designer relation

Followed

Kategori

3D Printer

Licens

Creative Commons Attribution NonCommercial ShareAlike Creative Commons Attribution-Noncommercial-Share Alike

$ ↺ SA

Attribution påkrævet; kommerciel brug er ikke tilladt; ShareAlike gælder for afledte værker.

Designer commercial

MakerWorld Commercial License

Først set

2026-07-15 10:58

Sidst set

2026-07-15 10:58

Tags

mount bracket mounting slides bambu reprack bambulab ams drawerslides bambu ams rack slide bambu ams mount ams reprack mount sliding drawer

Beskrivelse

Thank you so much for your Downloads, Like, Boosts! Become a Member at any tier & direct message me with your requests! Don't forget to Follow! After burning through multiple spools of filament with test prints, and a dozen modifications, I feel confident this is a great solution for a RepRack AMS mounting system. I will be posting detailed instructions if needed. This is a Project! I made it as plug-N-play as possible, but does require drawer slides. This is designed for the original 3-slot (Slots on side of original AMS) Does NOT screw into AMS, AMS slides onto the Right/Left Mounts. I used 10inch Drawer Slides found on Amazon: https://a.co/d/6Vsg7Ce RepRack Rod Bracket (Slides onto your conduit Rods) is the same model for left and right side. AMS Mount has a right and left side. IMPORTANT NOTE: I had to move a RepRack hanger to allow for space (the width of AMS Unit) and to be centered below my top reprack row. You might not have to do this. PRINT SETTINGS: Modified 100% Infil: I used slicer modifiers to set infill to 100% on the top of the Rod Brackets and the outside mounting point point for AMS Mounting brackets (Bambu Studio .3mf files attached). Mark brackets where your drawer slides will mount, and pre-drill for screws that came with drawer slides. It's solid! I used Polymaker PLA PRO Dark Grey (a.k.a. DarK2 Grey - K2 Dark Grey) 0.28 Layer Height NOTE: As long as your AMS can fit on one of your RepRacks between rows, mine are 9 ¼ inches between rows (Rod bottom to the below racks Rod Top) Other models waiting to be discovered… Boost Me (for free) Thank you so much for Rating, Following and the BOOSTS! Boost Membership Want to request a model or design change? You’ll need to be a member (any tier works!). Join up and send me a DM — so grateful for your support ❤️ Join