Drink Packet Organizer

Designer

JamesThePrinter

Designer relation

Followed

Kategori

Tools

Licens

Standard Digital File License

$ ↺

Se platformens konkrete vilkår.

Designer commercial

MakerWorld Commercial License

Først set

2026-07-15 10:58

Sidst set

2026-07-15 10:58

Tags

drinkpacket waterflavor holder organizer crystallight liquidiv kitchen office water Drink mix waterpacket flavorpacket packets packet diet

Beskrivelse

Organize your drink packets all in one place! Using the optional base, the entire organizer rotates for ease of use. This optional (but recommended) base requires the use of a standard 608 bearing. Print Settings The main organizer requires no special settings. The base should be printed with a high infill percentage. The extra weight will help keep the base steady while the organizer is spinning. I also recommend ironing the top surfaces of the base that will make contact with top section. Assembly Instructions Press a 608 bearing into the hole on the bottom of the organizer. This should be a tight fit. Set the organizer on the base so that everything aligns the same as below: Note: The connection between the base and the bearing is not a tight fit. This allows you to remove the base at anytime or swap it out for a different color. The following filaments were used in the pictures above: Bambu Lab Galaxy Nebulae PLA Buy Me A Coffee Membership Are you looking for a Commercial License for all JamesThePrinter models? Join