Headphones Stand - cob light

Designer

FlorinV

Designer relation

Followed

Kategori

Household

Licens

Standard Digital File License

$ ↺

Se platformens konkrete vilkår.

Designer commercial

Patreon

Først set

2026-07-15 10:58

Sidst set

2026-07-15 10:58

Tags

headphones stand support music sound desktop pc impossible passthrough lamp cob light holder cool headset headphones holder headsetholder headphonestand hanger mount

Beskrivelse

Check out my new 4th of July Glasses Features: *Can be used with or without a Cob Led Strip, as you wish. *All necessary hardware can be found on Bambu Maker's Supply. Bom list included. Optionally I would use an USB extender cable. *The part that holds the headphones is separated from the rest and can be printed with TPU, to have a soft pad. (eg Bambu TPU 95A HF) *No AMS is needed for a multicolor model. *The model uses the impossible passthrough design to connect the parts together and get a multicolor result. *You can use a translucent filament to better light passthrough. ( eg Bambu PETG Translucent ) Assembly: *It's nothing special, but please have a look at the exploded view bellow. *For the stand without light, you don't need anything else but the printed parts and optionally a bit of glue. *For the stand with light, you would need: - 20cm or 10cm cob led strip from Bambu Maker's Supply. ( i like it with a 20cm one, but depends on what you have or like ) https://eu.store.bambulab.com/products/cob-led-strip-light?id=42645878341768&modelId=707096 - USB-A power cable: https://eu.store.bambulab.com/en-ro/collections/electronics/products/usb-a-power-cable-with-ph2-0-connector - 50mm PH2.0 to SH1.0 Conversion Wire: https://eu.store.bambulab.com/en-ro/collections/electronics/products/50mm-ph2-0-to-sh1-0-conversion-wire *I would only use some glue after you first assemble all together one time, to see how everything is connected and to eventually clean some parts if needed for better connect each other. It may need a bit of glue to better hold the parts together if they are too loose. *This is the exploded view of the model: This is how the electronics look inside. This was my way of inserting them, but it can be done in different ways. *insert the cob led strip into the base upper part. *fix it with a bit of thin scotch / adhesive tape, on the opposite side of the two holes, like in the photo bellow. *guide the usb cable through the side hole of the base. If you use a Cob led strip with this model: Please don’t leave the light on unattended! Use on your own risk! Boost Me (for free) Any review / comment or boost is greatly appreciated! Thank you ! 🌍✌️ Boost You can check all my models → here. Or check my collection of my best models: https://makerworld.com/en/collections/1921582-my-best-models