Heli Flyer V1

Designer

Zurlingo3D

Designer relation

Followed

Kategori

Tools

Licens

Standard Digital File License

$ ↺

Se platformens konkrete vilkår.

Designer commercial

Patreon

Først set

2026-07-15 10:58

Sidst set

2026-07-15 10:58

Tags

flying helicopter pull copter hand pull rack and pinion kid toy toy airplane airplane

Beskrivelse

Heli Flyer V1 - A hand pull launcher that prints in less than 1 hour. Features: Very easy to print Easy assembly (1 dab of super glue required) Under 1hr print time No support needed Fun for kids and big kids Simple and effective rack and pinion design The propeller/rotor launches over 15 feet in the air with a good pull Only uses 20g of filament per Heli Assembly: Push the skids into the body until fully seated. Face the flat sides inward for the best aesthetic. Add a small amount of super glue to the pin of the ‘Gear’ and push the ‘Propeller’ in place. Allow the glue to fully set, or use some activator before testing it out. Usage: Insert the ‘Rack’ into the ‘Body’. There is a small slot in the ‘Rack’ and a small protrusion in the ‘Body’ to help guide the ‘Rack’ into the correct place. Drop the ‘Propeller’ onto the pin in the centre of the ‘Body’ Push the ‘Rack’ to the forward position Pull it back as fast and straight as you can using the ring-pull at the rear. This is great fun for kids and is easy enough for younger kids to operate themselves (My 5 year old got it in no time) I hope you like it! :) Commercial license is available through an active Patreon subscription or on a per model basis here: https://patreon.com/user?u=107266418&utm_medium=unknown&utm_source=join_link&utm_campaign=creatorshare_creator&utm_content=copyLink Please rate and review your printing experience :) Thanks for looking!